1. Nhanganyaya
Thank you for choosing the oneisall Dog Clippers. This grooming kit is designed to provide a quiet and efficient grooming experience for your pets. Please read this manual thoroughly before use to ensure proper operation and maintenance.
2. Safety Information
- Keep the appliance dry. Do not immerse in water or use in wet conditions.
- Chengetedza kure nevana nemhuka dzinovaraidza kana dzisiri kushandiswa.
- Do not attempt to disassemble or repair the unit yourself. Contact customer support if needed.
- Ensure the clipper is fully charged before first use. Avoid overcharging to prevent battery damage.
- Always check the blades for any damage or debris before and after each use.
- Shandisa chete tambo yekuchaja yakapihwa.
3. Chii Chinosanganisirwa
Your oneisall Dog Grooming Kit includes:
- oneisall Dog Grooming Clipper
- 6 Guide Guards (3mm, 6mm, 9mm, 12mm, 15mm, 18mm)
- Kuchenesa Brush
- Comb
- Chigero
- USB Kuchaja Cable

4. Setup
4.1. Charging the Clipper
The clipper features a 2000mA high-capacity Li-ion battery.
- Connect the USB charging cable to the clipper and a suitable USB power adapter (not included).
- Charge for approximately 3 hours for a full charge. The intelligent LCD display will indicate the charging status.
- Dzivisa kuwandisa kuti urebese hupenyu hwebhatiri.

4.2. Attaching and Removing Guide Guards
Select the desired guide guard (3mm, 6mm, 9mm, 12mm, 15mm, or 18mm) for your pet's coat length.
- To attach: Align the guide guard with the clipper blade and slide it on until it clicks securely into place.
- To remove: Gently push the guard away from the blade.

5. Operating Instructions
5.1. Powering On/Off and Speed Adjustment
The clipper features a simple one-button operation for power and speed.
- To turn on: Press the ON/OFF button. The clipper will start at the default speed.
- To adjust speed: Press the ON/OFF button again to switch between the two speeds (5000 RPM and 5700 RPM).
- To turn off: Press the ON/OFF button until the clipper stops.

5.2. Adjusting Blade Length
The ceramic blade can be adjusted from 0.8mm to 2.0mm using the rotating dial on the clipper body. This allows for precise trimming without a guide comb or fine-tuning with one.

5.3. Grooming Your Pet
- Ensure your pet's coat is clean, dry, and free of tangles before grooming. Use the included comb to brush out any knots.
- Tanga nemuzinga wakareba kana usina chokwadi chehurefu hwaunoda.
- Hold the clipper firmly and move it in the direction of hair growth.
- The ultra-quiet 50db low noise design helps keep pets calm during grooming.

6. Kuchengeta
6.1. Kuchenesa Mablades
Kuchenesa nguva dzose kunovimbisa kushanda kwakakwana uye utsanana.
- Dzima clipper.
- Detach the blade by pushing it forward.
- Use the included cleaning brush to remove any hair or debris from the blades and the clipper head.
- The removed blade part can be directly washed under water for thorough cleaning. Ensure it is completely dry before reattaching.
- Reattach the blade by aligning it and pushing it back until it clicks.
6.2. Oiling the Blades
Apply a few drops of clipper oil (not included in this kit, but recommended for maintenance) to the blades regularly to keep them sharp and running smoothly.
7. Kugadzirisa matambudziko
7.1. Clipper Not Turning On
- Tarisa kana bhatiri rakachajwa. Rongedzazve kana zvichidikanwa.
- Ensure the ON/OFF button is pressed correctly.
7.2. Poor Cutting Performance
- Chenesa mablades kuti ubvise chero bvudzi rakavharirwa kana marara.
- Ensure the blades are properly oiled.
- Check if the blade length adjustment is set correctly for the coat type.
- Ensure the guide comb is securely attached.
7.3. Clipper Overheating
- Turn off the clipper and allow it to cool down.
- Clean and oil the blades.
- Avoid continuous use for extended periods; take breaks if grooming a large pet.
8. Zvinotsanangurwa
| Feature | Detail |
|---|---|
| Model | B0F4429CDX |
| Brand | oneisall |
| Bhatiri Type | 2000mA High Capacity Li-ion Battery |
| Kuchaja Nguva | Approx. 3 maawa |
| Nguva Yekushanda | Kusvikira kumaminitsi makumi matatu |
| Noise Level | Approx. 50db |
| Speed Settings | 2 speeds (5000 RPM and 5700 RPM) |
| Blade Adjustment | 0.8mm - 2.0mm |
| Guide Combs | 3mm, 6mm, 9mm, 12mm, 15mm, 18mm (6 total) |
| Simba Source | Rechargeable (Cordless use, can be used while charging) |
| Package Dimensions | 9.06 x 7.8 x 2.2 inches |
| Kurema | 1.23 Pondo |
| Zuva Rokutanga Kuwanikwa | Kubvumbi 1, 2025 |
9. Warranty uye Tsigiro
For warranty information or customer support, please contact oneisall directly.
Zvirongwa zvekudzivirira zviripo kuti zvitengeswe zvakasiyana:
- 2-Yegore Dziviriro Chirongwa
- 3-Yegore Dziviriro Chirongwa
- Zadzisa Dziviriro (chirongwa chemwedzi nemwedzi chinovhara kutenga kwakakodzera)
Return Policy: 30-day refund/replacement policy.