Isa gwaro
CSEN1

CSEN1 Combo Sensor Controller

Part Numbers: CSEN1-H-W-ZHA (white enclosure) and CSEN1-H-G-ZHA (gray enclosure)

DESCRIPTION

The CSEN1 is a low voltage Networked Lighting Controller with an integrated passive infrared sensor and a photocell. It is powered via the AUX power from the LED driver. The CSEN1 autodetects both 0-10V Drivers and D4i Drivers to simplify the installation. The product is DLC certified for both indoor and outdoor applications.

SECIFICATIONS

• Radio Frequency: 2.4 GHz (IEEE 802.15.4)
• RF Transmission Output Power: +20dBM
• Kushanda Tembiricha: -40° kusvika +70°C
• Kushanda Humidity: 10 kusvika 95%, isina-condensing
• IP66 Yakatemerwa Enclosure
• Zviyero: 3.1" D x 1.6" H (80mm D x 42mm H)
• Input Power: 12-24VDC, 35mA max, 840mW
• Chinangwa chekutonga: Kushanda
• Environmental: Indoor/Outdoor
• Dhigirii rekusvibisa: 3
• Yakatemwa Impulse Voltage: 330v

GADZIRA ZVOKUFUNGA

Below are some recommendations for successful analog dimming using the CSEN1. The analog dimming control wires are referenced as DALI+/DIM+ and Common Ground/DALI-. The dimming signals have a Maximum voltage ye10V DC.

• Do not ground the Common Ground/DALI- wire to chassis ground; this is a return signal and is critical for proper dimming.
• Kana zvichibvira, fambisa waya dziri kure nemitsara yeAC.
• Maximum of 4 DALI-2/D4i LED Drivers per controller, bvunza Synapse Support kana chiyero chikuru chichidiwa.
• Maximum of 8 DIM to OFF LED Drivers for DIM to OFF Designs.
• Usakwira kune heatsink kana kumutyairi we LED.

CHERECHEDZA: LED Driver inofanirwa kutsigira DIM kune OFF kushanda.
YAMBIRO UYE CHENJERERO

• TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE INSTALLING OR SERVICING!
• The CSEN1 should only be installed in a fixture with a Zhaga Book 18 receptacle.
• Kutadza kutevedzera mirairo iyi uye yambiro zvinogona kukanganisa waranti.
• This product must be installed in accordance with national, state, and local electrical codes and requirements.
• If you are unsure about any part of these instructions, consult an electrician; qualified personnel should perform all work.

WIRING DETAILS OF ZHAGA BOOK 18 SOCKET

TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE INSTALLING OR SERVICING!
For fixtures with an existing Zhaga socket, prior to installation, verify the wiring per the details below. (See Figure 1) If the fixture does not have a Zhaga socket, use the appropriate Wired Adapter accessory based on the knockout size: CSEN1-ZHA-ADPT-22 for 22mm knockouts, or CSEN1-ZHA-ADPT-33 for 33mm knockouts. The specifications for the signal wires are:

• 12-24VDC POWER: Brown
• Common Ground/DALI-: Pink with White Stripe
• DALI+/DIM+: Violet with White Stripe
• Solid Conductor, 105°C, Rated for 600VAC, AWG 20, 15” Length

MUFANANIDZO 1

INSTALLATION MIrairo

TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE INSTALLING OR SERVICING!

1. Kana zvichibvira, bvisa chivharo chevhavha kana chigadziriso chekuvhenekesa chaiswa izvozvi mumudziyo wekugadzirisa.
2. Align the CSEN1 such that the contacts pins are positioned at the appropriate the receptacle contacts.
3. After alignment, push until the CSEN1 is fully seated within the receptacle.
4. While pushing against the device, twist the CSEN1 housing clockwise until it locks into place. The CSEN1 includes a latching key or notch that will lock into position with an audible “click”. (See Figure 2)

Cherechedza: Kuti ushande nemazvo, ita shuwa kuti controller yakaiswa zvachose musocket uye yakamonyoroka munzvimbo yakakiiwa.
Yambiro: The Zhaga receptacle should not turn during installation. Turning the receptacle could damage the internal fixture wiring by pulling it loose.
MUFANANIDZO 2

STATUS LEDS

REGULATORY INFORMATION AND CERTIFICATIONS
RF Exposure Statement: Ichi chishandiso chinoenderana neFCC radiation exposure miganho yakatemerwa nharaunda isingadzoreki. Mudziyo uyu unofanirwa kuiswa uye kushandirwa nedikidiki chinhambwe che20cm pakati pe radiator nemuviri wako. Iyi transmitter haifanirwe kunge yakabatana kana kushanda pamwe chete nechero imwe antenna kana transmitter.
Indasitiri Canada (IC) zvitupa: Ichi chishandiso chedhijitari hachipfuure miganhu yeKirasi B yekuburitsa ruzha rweredhiyo kubva kumidziyo yedhijitari yakarongwa muRadio Interference Regulations yeCanada Dhipatimendi Rezvekutaurirana.
FCC certification uye ruzivo rwekutonga (USA chete)
FCC Chikamu 15 Kirasi B: Chishandiso ichi chinoenderana nechikamu 15 chemitemo yeFCC. Kushanda kunoenderana nemamiriro maviri anotevera: (1) Midziyo iyi inogona kusakonzeresa kukanganisa, uye (2) Zvishandiso izvi zvinofanirwa kugamuchira chero kukanganisa kwakagamuchirwa, kusanganisira kukanganisa kunogona kukonzera kukuvadza kushanda.
RADIO FREQUENCY INTERFERENCE (RFI) (FCC 15.105): Midziyo iyi yakaedzwa uye yakawanikwa inoenderana nemiganhu yeKirasi B yedhijitari mudziyo, zvichienderana neChikamu 15 chemitemo yeFCC. Iyi miganho yakagadzirirwa kupa dziviriro inonzwisisika kubva mukukanganisa kunokuvadza mukuiswa kwekugara. Midziyo iyi inogadzira, inoshandisa, uye inogona kuvheneka redhiyo frequency simba uye, kana isina kuiswa uye kushandiswa zvinoenderana nemirairo, inogona kukonzera kukanganisa kunokanganisa kufambiswa kweredhiyo. Nekudaro, hapana vimbiso yekuti kukanganisa hakuzoitika mune imwe yekumisikidza. Kana mudziyo uyu ukakonzera kukanganisa kunokuvadza paredhiyo kana kutambira terevhizheni, izvo zvinogona kutariswa nekudzima uye nekubatidza mudziyo, mushandisi anokurudzirwa kuedza kugadzirisa kukanganiswa neimwe kana anopfuura eanotevera matanho: (1) Tangisaizve nhanho. kana kutamisa antenna yekugamuchira; (2) Wedzera kupatsanurwa pakati pemidziyo nemugamuchiri; (3) Batanidza midziyo muchiteshi pane dunhu rakasiyana neiyo iyo mugamuchiri anobatanidzwa; (4) Bvunza mutengesi kana nyanzvi ine ruzivo rweredhiyo/TV kuti ubatsirwe.
Declaration of Conformity (FCC 96-208 & 95-19): Synapse Wireless, Inc. declares that the product name CSEN1 to which this declaration relates, meet the requirements specified by the Federal Communications Commission as detailed in the following specifications:

• Chikamu 15, Chikamu B, cheKirasi B michina
• FCC 96-208 sezvainoshanda kumakomputa emunhu eKirasi B uye maperipheral
• Ichi chigadzirwa chakaedzwa kuExternal Test Laboratory yakasimbiswa maererano nemitemo yeFCC uye yakawanikwa ichisangana neFCC, Chikamu 15, Emission Limits. Documentation is on file uye inowanikwa kubva kuSynapse Wireless, Inc.

Kana iyo FCC ID yemodule mukati meichi chivharo chakavharika isingaonekwe kana yaiswa mukati meimwe mudziyo, ipapo kunze kwemudziyo wakaisirwa chigadzirwa ichi kunofanirwawo kuratidza label inoreva kune yakavharirwa module FCC ID. Kugadziridza (FCC 15.21):
Shanduko kana gadziridzo kumudziyo uyu usina kutenderwa zvakajeka neSynapse Wireless, Inc., zvinogona kukanganisa masimba emushandisi ekushandisa mudziyo uyu.
Patented - chaiyo yekumaka pa https://www.synapsewireless.com/about/patents
Kuti udzidze zvakawanda shanya: synapsewireless.com

ZVIMBO

DALI-2 Certified Application Controller

Zvinyorwa / Zvishandiso

Synapse CSEN1 Combo Sensor Controller [pdf] Installation Guide CSEN1-H-W-ZHA, CSEN1-H-G-ZHA, CSEN1 Combo Sensor Controller, CSEN1, Combo Sensor Controller, Sensor Controller, Controller

References

• User Manual