1. Chigadzirwa Pamusoroview
The Sicce Ultrazero Flat Sucking Pump is designed for efficient removal of water from various areas, including flooded cellars, garages, and other spaces where minimal residual water is desired. This submersible pump is capable of reducing water levels down to 2-3 mm.
Zvinokosha:
- Capable of pumping water down to 2 mm residual level.
- Fully submersible design.
- Handles dirt particles up to 3 mm in size.
- Equipped with a 10-meter power cable.
- Features a practical carry handle for easy transport.
Mufananidzo 1: Kupfuuraview of the Sicce Ultrazero Flat Sucking Pump.
2. Safety Information
Read all safety warnings and instructions before operating the pump. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- Gara uchibvisa pombi kubva pamagetsi usati waibata, kuichenesa, kana kuita chero kugadzirisa.
- Ita shuwa kuti magetsi emagetsi awandatage matches the pump's specifications (230 V/50 Hz).
- Do not operate the pump with a damaged power cord or plug. If damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid a hazard.
- Do not use the pump to handle flammable or explosive liquids.
- Chengetedza vana uye vanhu vasina mvumo kure nenzvimbo yekushanda.
- Ensure the pump is fully submerged during operation to prevent overheating.
- Avoid running the pump dry for extended periods.
- This pump is designed for water only. Do not use it for other liquids without consulting the manufacturer.
3. Setup uye Kuiswa
Follow these steps to properly set up your Ultrazero pump:
- Bvisa Pombi: Bvisa pombi nekungwarira nezvimwe zvese zvinoshandiswa kubva mupakeji. Tarisa kana paine kukuvara.
- Connect the Discharge Hose:
The pump features a 26.44 mm (3/4") AG pressure connection. Attach a suitable discharge hose (e.g., 20 mm (3/4") hose connection) to this outlet. Ensure the connection is secure to prevent leaks.
Figure 2: Close-up of the pump's discharge outlet and integrated carry handle.
- Isa Pombi: Place the pump directly on the surface from which water needs to be removed. Ensure the pump is stable and upright. The flat base allows for efficient water removal down to minimal levels.
- Route the Discharge Hose: Direct the discharge hose to a suitable drainage area, ensuring the water will not flow back into the area being drained.
- Power Connection: Plug the 10-meter power cable into a grounded 230 V/50 Hz electrical outlet. Ensure the outlet is protected by a Ground Fault Circuit Interrupter (GFCI) for added safety, especially in wet environments.
Figure 3: The flat base of the pump designed for low residual water levels.
4. Operating Instructions
The Ultrazero pump is designed for simple operation:
- Nyura Pombi: Ensure the pump is fully submerged in the water you wish to remove. The pump requires water to cool its motor and operate correctly.
- Tanga Kupomba: Once submerged and connected to power, the pump will begin operating automatically. It does not feature a float switch, so manual monitoring is required for optimal use.
- Monitor Mwero weMvura: The pump will continue to operate until the water level reaches its minimum suction capability of 2-3 mm.
- Stop Pumping: To stop the pump, disconnect it from the power supply. It is recommended to disconnect the pump once the desired water level is reached or if the pump starts to run dry.
Figure 4: The Ultrazero pump effectively draining water from a small pool.
Figure 5: The pump in action on a flooded floor, demonstrating its low-level suction capability.
Figure 6: Illustration of the pump's ability to reduce water levels to approximately 2 mm.
5. Kuchengeta
Kugara kugadziridza kunovimbisa hupenyu hurefu uye kuita kwakakwana kwepombi yako.
- Kuchenesa: After each use, especially when pumping dirty water, rinse the pump thoroughly with clean water. This helps prevent sediment buildup.
- Ongorora Marara: Periodically check the pump's intake area for any debris (e.g., leaves, small stones) that might obstruct water flow. Remove any blockages carefully after disconnecting power.
- Cable Inspection: Regularly inspect the power cable for cuts, abrasions, or other damage. Do not use the pump if the cable is damaged.
- Kuchengeta: When not in use, store the pump in a clean, dry place, protected from frost.
Figure 7: The pump can also be used for transferring water for tasks like garden watering from a rain barrel.
6. Kugadzirisa matambudziko
If you encounter issues with your Ultrazero pump, refer to the following common problems and solutions:
| Dambudziko | Zvinogona Kukonzera | Solution |
|---|---|---|
| Pombi haina kutanga. | Hapana magetsi. Tambo yemagetsi yakuvadzwa. Dziviriro yemota yakawandisa inoshanda. | Tarisa simba rekubatanidza uye kubuda. Inspect cable for damage; replace if necessary (by qualified personnel). Disconnect power, allow motor to cool, then reconnect. |
| Pombi inomhanya asi hapana mvura inobuda. | Intake blocked. Hosipaipi yekubuditsa mvura yakapwanyika kana kuti yakavharika. Airlock in pump. | Disconnect power, clear intake. Check and clear discharge hose. Briefly lift and lower the pump while submerged to release trapped air. |
| Reduced pumping performance. | Partial blockage. Impeller worn. | Disconnect power, clean pump intake and impeller area. Bata rutsigiro rwevatengi kuti uwane sevhisi. |
| Pombi inomira zvisingatarisirwi. | Overheating due to low water level or blockage. Kukanganisa kwemagetsi. | Disconnect power, check water level and clear blockages. Allow to cool. Kana dambudziko rikaramba riripo, bata rutsigiro rwevatengi. |
If the problem persists after attempting these solutions, please contact Sicce customer support.
7. Zvinyorwa zveUnyanzvi
Detailed specifications for the Sicce Ultrazero Flat Sucking Pump, Model 925607:
| Tsanangudzo | Value |
|---|---|
| Brand | Sice |
| Model Number | 925607 |
| Max. Delivery Rate (Flow Rate) | 3000 l/h |
| Max. Delivery Kureba | 3.1 m |
| Power Consumption (P1) | 80 W |
| Kushanda Voltage | 220-240V/50Hz |
| Conductor Length (Power Cable) | 10 m (three-core, indoor and outdoor use) |
| Pressure Connection | 26.44 mm (3/4") AG |
| Dhayamita yekubatanidza hosipaipi | 20 mm (3/4") |
| Max. Solids Size | 3 mm |
| Residual Water Level | Down to 2-3 mm |
| Zviyero zveChigadzirwa (Approx.) | 140 mm (Diameter) x 160 mm (Height) / 5.5" x 6.3" |
| Item Weight | 2.6 kg (5.72 lbs) |
| Kuyangarara chinja | Aihwa |
| Overload Dziviriro | No (Internal thermal protection may exist, but no external reset) |
| Origin | Yakagadzirwa muItaly |
Figure 8: Technical drawing illustrating the pump's dimensions and 3/4" GAS connection.
8. Warranty uye Tsigiro
For warranty information or technical support regarding your Sicce Ultrazero Flat Sucking Pump, please contact Sicce customer service. Keep your purchase receipt and model number (925607) handy when contacting support.
Mugadziri: Ebara
Brand: Sice
For further assistance, visit the official Sicce websaiti kana kubata muparidzi wenzvimbo yako.
